Machsupport Forum
Mach Discussion => FAQs => Topic started by: marcberv on August 12, 2011, 09:31:37 AM
-
I have Mach3 running with one parallel port running on a notebook without any problems (after buffering the port)
I want extend the input capacity of my system, can any body confirm if a PCMCIA Parallel adapter does function with Mach3?
In case of not compatible, is there an other solution to provide a 2nd parallel port?
Thanks
marcberv
-
MOst do fine.
(;-) TP
-
I use two of them in my Desk Top with GECKO 540s one for mill other for lathe