Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: TJN on August 09, 2011, 07:08:14 PM
-
I have used Mach 1 for years, now I finally am getting around to upgrading to Mach 3. The install went well, thedriver test went well, but the dro does not change when I press the arrow keys, nor when a loaded program runs, What could be the problem?
-
Sounds like you do not have the motors enabled in Ports and Pins.
Hood
-
Thanks Hood, that was it
-
:) No probs
Hood