Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: ThomasCB21 on August 09, 2011, 12:54:19 PM

Title: Good Vendor for L Type Gearing
Post by: ThomasCB21 on August 09, 2011, 12:54:19 PM

Hi folks,

I know this is probably not the place to ask.  I have been asking questions and I have been getting my plans together.  So my next question is,  "Who know of a good and reasonable (cheap, cheap goes the birdy! :D ) vendor that sells L Type Gears? (these use a size 75 synchronous type belt)"  As always any information is greatly appreciated and adds to my knowledge base.

Thanks,
Chris

Title: Re: Good Vendor for L Type Gearing
Post by: RICH on August 11, 2011, 07:13:16 PM

Try MSG Industrial Supply as they may have plastic ones.

 Heck, make your owne from bar stock borrowed from a friend and make sure you get the cutter to go with the stock! >:D
You did say cheap cheap ........ ;) :) :D ;D

RICH

Title: Re: Good Vendor for L Type Gearing
Post by: ThomasCB21 on August 11, 2011, 08:51:07 PM

Thanks Rich, I'll check them out.  Say can I borrow some bar stock and the cutter?  :D

Chris

Title: Re: Good Vendor for L Type Gearing
Post by: RICH on August 12, 2011, 05:53:11 AM

Sorry Chris,
Can't lend you anything....my friends do all my programming and machining.  ??? ;)
RICH