Machsupport Forum
Third party software and hardware support forums. => Mach3 and G-Rex => Topic started by: dazza111 on July 28, 2011, 07:13:09 PM
-
hi guys im a newbie and struggling with mach 3 im running it on a lap top i know this is not recommended but i will get pc once i work out if it will help solve my prob The problem is i run the code (engraving) when it starts cutting its at the correct z axis depth but every time the cutter goes to job it cuts progressively deeper on every letter this is killing me mentally
-
Lower the Z axis velocity and acceleration in half, and see if that helps.
Keep in mind that it's entirely possible that the laptop is the cause.
-
went a got a p/c to run it so ill try that thanx
-
tryd new p/c still no good this is doing my head in :'(