Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: AAASIGNCOM on July 21, 2011, 10:42:30 PM
-
HELLO, I HAD AN AUTOMATIC WINDOWS UPDATE OR A POWER SERGE AND NOW MACH IS NOT CONNECTED TO THE MACHINE. THE DRO DO NOT CHANGE AND THE DIAG LEDs DO NOT LIGHT UP. I HAVE PLENTY OF WORK AND THIS IS NO TIME TO MESS UP. CAN ANYONE HELP ME. I AM IN INDIANAPOLIS, IN. USA. IS THERE ANYONE OUT THERE I CAN CALL TO WALK ME THROUGH THE SETUP. THANK YOU. TONY ROGERS
-
If the DROs are not changing when you jog then its either you have a faulty keyboard, the Jog Control is switched off or you have no axis enabled.
If you attach your xml I can have a look and see if I can find an issue.
Hood
-
HI HOOD, THANKS FOR LOOKING. I AM PUPPING BOTH OF MY HAIRS OUT. THANK YOU TONY
-
I HAVE 2 PCI LPT 2 & 3 PORTS THAT RUNS THE CONTROLLER. I ALSO THINK THE LPT ADRESSES CHANGED. LAST NITE I HAD THE DROs CHANGING WITH KEYBOARD. THIS MORNING THE DROs ARS NOT WOTKING
-
I have just tried your xml and when I jog with the keyboard the DROs change, if yours are not then it would seem to be an issue with your keyboard (assuming you are using the same xml)
Hood
-
Please do not type in all Caps.
Thanks
-
HOOD, THANK YOU FOR TAKING TIME TO REVIEW MY FILE. I DELETED EVERYTHING AND STARTED OVER WITH A MACH UPGRADE. UNDERSTANDING THE PORT ADDRESS SYNTAX THROUGH MR OFF. BUT I AM UP AND RUNNUNG, JUST NEED TO TUNE AND TWEEK. THANK YOU AGAIN. TONY IN INDIANAPOLIS, IN 46254 USA
-
Good you got it :)
Hood
-
AAASIGNCOM,
Good you got it
Well almost............turn the caps off please as it makes for easier reading and you won't wake the neighbors up when shouting..... ;)
RICH