Machsupport Forum
G-Code, CAD, and CAM => G-Code, CAD, and CAM discussions => Topic started by: Alex Lech on July 21, 2011, 10:54:21 AM
-
So I am pretty new to this kind of stuff, and I don't really know what I'm doing but I'm trying to figure it out. I have a line in my g code that every time it gets to this line it says "radius to end of arc differs from radius to startline," and then it proceeds to carve a big circle. Here is the line of g code where it gets stuck:
N2050G2X12.778Y1.6971-0.093J0.030
I could really use some help.
Thanks in advanced
-
Hi Alex,
Welcome to the forum.
If you click menu Config / General Config then set the "IJ Mode" to the opposite of what it is currently set to - that should cure it.
Tweakie.