Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: ErnieD on July 21, 2011, 12:29:41 AM
-
Hi,
I have a Tormach PCNC 1100 running on Mach3. I have a computer in the house that has Mach3 loaded on it. I use the house computer to prerun the programs and if I like them I put them on USB stick and take them out to the garage and do the machining.
I just tried to do this tonight and when i loaded the Mach3 I got a blank screen. Anybody have an idea what might be wrong?
Thanks,
Ernie
-
Hi Ernie,
Are you saying that Mach did not load on your garage PC or that the program from the memory stick did not load ?
Tweakie.
-
Do you mean it doesn't load the screenset? I've noticed that the latest version takes longer to load the screenset than earlier versions, but it does do it after a few seconds. I'm wondering if your XML has become corrupted and points at a non-existant screenset OR your screenset has gone awol.
what happens if you do a view / load screen and browse for a screenset?
Ian
-
Hi,
It would not load the screen set. I finally went to view, load screens and chose the screen set for my mill PCNC 1100 and it loaded. It has been loading fine ever since. I got the tip on how to do this on another forum.
Thanks,
Ernie
-
Sounds like a handy forum Ernie. ;D
Tweakie.
-
It was either CNCZONE or Practical Machinist. Both are very good and I visit them every day.
Ernie
-
I guess it must be me...
-
I thought that Ian but didn't like to say ;D
Tweakie.
-
Thanks Tweakie - If you're bored, this might amuse you http://www.machsupport.com/forum/index.php/topic,18390.0.html (http://www.machsupport.com/forum/index.php/topic,18390.0.html). Sometimes I do wonder why I bother.
Ian