Machsupport Forum

Mach Discussion => Mach Screens => Machscreen Screen Designer => Topic started by: zafarsalam on July 08, 2011, 08:51:11 AM

Title: can't see lathe toolpath in mach
Post by: zafarsalam on July 08, 2011, 08:51:11 AM

Hi,

This is the first time I am designing a lathe screen. Seem to have stuck at a point which never gave me trouble with Mill screens. I add a toolpath, assign it's direction X-Z for lathe, save the file and when I open the screen in Mach3 then the toolpath is not there. Am I missing something? I have used V1.44 and V1.51 with the same results.

Zafar

Title: Re: can't see lathe toolpath in mach
Post by: zafarsalam on July 09, 2011, 01:00:48 AM

I used swap layers and that salved the problem.

Zafar