Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: mikee on July 04, 2011, 06:42:46 PM
-
good day everyone
my 6in round circles are not round
there are 2 flat spots one on each side of the circle at 3,30 to 4 o clock and 180 % out 930 to 10 o'clock.
both flat spot are about 1.5 long inches the same .
this where i guess. I'm thinking it is backlash and its OK if I'm thinking wrong
i am reading my manual as i am writing this.
if this is a backlash adjustment how do i know which axis to set or have a problem with. I'm at 1511 units per inch
is there troubleshooting manual or a book that i can get or buy, download.
it is hard to keep on asking questions I'm sure the answer is in my manual .
p.s i check on some schools here in town to see if i could pick up a class on cad /cam . it is very sad no classes, closest class is 165 miles one way.
once again thank you for helping me
Mike
-
found problem
Y axis sprocket loose.
on to new problems
mikee
-
Does anyone use JDPaint 5.5 or Type 3 with mach3?