Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: aircastle on July 01, 2011, 02:59:22 PM
-
This should be easy, but I have had no success so far. I have 3 signals (left door, right door and power fail) that have LEDs on the screen, but I can't get the signals to put Mach into the Reset or E-stop condition. If any of these signals come on, I want the user to push Reset to get going again.
Thanks for any hints you might offer.
-
Could do it via a Brain or a macropump.
What you would do in either is look at the state of the LEDs and call a Reset.
A Brain something like this would work I think.
Hood