Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: rich05 on July 01, 2011, 10:51:15 AM
-
Arrow keys are not moving my mill table, page up and page down not moving the z axis, I just installed latest release and having some serious problems .
the mill is responding to g code, manual input.
has there been some change to hotkey commands? is there some stop mode that locks the jog keys out when a nc file is loaded,
UPDATE,,, GAH sometimes I just have to post in order give bettter luck, right after posting found that jog was turned off? Never seen this before is this a new option of the program when you load and NC file? Does it turn jog mode off now? I need that on my thinks. Thanks
-
Doesnt happen here, was it just a one off or is it always happening?
Hood
-
probablly a one off , thanks.
-
CTRL-J is the hotkey to turn jogging on and off. it could have been an errant keystroke.
Mike