Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: acieradave on June 11, 2011, 05:11:57 AM

Title: Set offset in Klaus' camera plugin?
Post by: acieradave on June 11, 2011, 05:11:57 AM

Hello everybody,

I just installed Klaus' Camera Plugin. Everthing works fine except that I can't figure out how to set the offset and that the coordinates don't show up when the box in the video window is checked. Any ideas?
Otherwise many thanks for the great work Klaus!

Dave

Title: Re: Set offset in Klaus' camera plugin?
Post by: Klaus1311 on June 11, 2011, 08:25:14 AM

Hi Dave,

after start of Mach3 go to Config->Config plugins WebCamPlugin CONFIG. In that dialog you can set the X and Y-offset. Once the offset is set, open the "Dialog Settings" dialog on bottom of the camera screen. In that dialog you'll see the button "move offset". This button is only enabled, if Mach3 is not reset.

Klaus

Title: Re: Set offset in Klaus' camera plugin?
Post by: acieradave on June 11, 2011, 08:37:28 AM

Cool!

Works like a charm.

Thanks again Klaus

Dave