Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: skimpro on December 01, 2006, 11:27:01 PM

Title: Driver test
Post by: skimpro on December 01, 2006, 11:27:01 PM

I have been trying to get Mach 3 to work with my computer and gecko drives . I have checked everything I can think of and still can't get any motor movement. The one thing that seems odd is when I run a driver test a message comes up that says "Could not locate missing vectors". When I close the window and run the test again, the test will then work. Could this be a clue as to why I can't get anything to work?

Title: Re: Driver test
Post by: redpiperbob on December 02, 2006, 08:27:27 AM

Hi Skimpro I got the "vector" message when I had the Mach 3 programme running when I did the driver test
Bob