Machsupport Forum
Third party software and hardware support forums. => Third party software and hardware support forums. => Topic started by: Diverp on June 06, 2011, 04:54:05 PM
-
Hello,
I am curious as to if there is a way to use a digitizing probe, while utilizing the 4th, angular axis? Is this something that can be done now?
Thank you
-
YES mach does XYZ and A.
(;-) TP
-
I am running Bob Campbells Mach 3 box with a series 1. He suggested I connect the TP100 digitzing probe to the A limit, using port 1 pin 15, but I since I have an A axis that I would like to probe to, is there another point for this input?