Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: air2gnd on June 05, 2011, 08:25:15 AM
-
I have a controller box made for me, the unit came with 3 prox switchs . The question is where would the best placement for these switches and what would be the best setting for these. I mean: home ++/-- setting for all axises.
Thank you
air2gnd
PS
Thanks Rich your response.
-
Best to have the switches set mid axis if possible and have a trigger either end so that you have one switch being used for both positive and negative of an axis.
Hood
-
Thanks Hood! I have been following all your posts. You are a wealth of knowledge!!!!!
air2gnd
-
I post plenty, whether a wealth of knowledge or crap will depend on the opinion of who is reading ;)
Hood