Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Riley on May 28, 2011, 09:41:47 PM
-
For some reason after I do a tool change the feedrate override will sometimes increase....has anyone seen this before?
-
::) OK...just found out that F10 is both tool clamp AND feedrate override. I had not realized there were keyboard shortcuts for feedrate override when I assigned the tool clamp/unclamp. My bad.
-
That is a classic example of why I personally dislike using HotKeys.
I think Klaus's MachScreen programme tells you if you have duplicates or possibly it gives a list of what you are using but always worth checking if you plan to use HotKeys.
Hood
-
Thanks for the input....I will look into that. One more thing that happens once in a while is if I hit stop (not e-stop) while running a program I lose jogging. Have tried to disable/enable jog mode but nothing. Even have tried MDI and the DRO moves but not the table, then the DRO goes back to where it was. After hitting and releasing E-stop all is good again. I am using a third party motion board, made by ajax. Any thoughts?