Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: MattJ on May 26, 2011, 05:29:24 PM
-
Hello Anybody/Everybody,
My name is Matt and I have a problem, and no, an ointment won't cure it!
I am running a job and the feeds are considerably less than programmed.
I know it is something I am not doing right and I have tried to look for a solution.
Background...I import a DXF into Dolphin Cam which worked great.
Used a Mach 3 Inc post processor, that works fine.
My feed rate is programmed at 100ip. I bring the job into Mach 3 and it looks fine
tool paths are OK. I then cycle the job and the feed rates are about 1/3.
I did a test with a circle wizard and that worked fine.
I'll try to attach my xml if I can figure out how to.
Thanks in advance! I type about 3 words per minute, so if I left out anything,
let me know!
-
Your Z axis has a max velocity of 30 IPM, thus if there is a combination move the slower axis defines the feed rate.
RICH
-
Rich, Thank You!
I just got home. I will make that adjustment right now.
Again, Thanks!
-
I should have figured it would not be that easy.
Now I get a notice telling me that the PWM has been set to minimum.
I still get much slower feedrates than programed.
-
Try doing a simple test. Can each of your axis do the max vel as set in config?
Next try a long move in 3 axis at the same time something like X10 Y10 Z5 do you reach programmed velocity.
It may be your gcode has too many short segments and the machine never gets a chance to reach max velocity. Low accellaration values can cause this as well
Maybe your kernal speed is too low to reach max velocity?
Just a some thoughts, (;-) TP
-
BR549, Thank You
I adjusted my accellaration higher and it did increase my feedrates!
They almost doubled, which is a big help.
I do believe you are correct about the short segment issue.
Obviously I am a newbie, maybe in ten or twenty years I might get a hang of this!
Thanks