Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Jackal on May 23, 2011, 05:15:42 PM
-
It's time for the step & direction wires from the B_O_B to the Geckos.
Do these need to be shielded cable?
If so, what gauge?
I have some of the shielded cable left from the factory wiring. It's not very heavy gauge.
Thanks,
JAckal
-
Dont need to be heavy, not sure of your USA gauges but just signal wiring is needed but definitely shielded in my opinion.
Hood
-
Would encoder wire work?
JAckal
-
Would be perfect, encoder signals and step/dir signals are basically the same thing :)
Hood