Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: DonH on May 21, 2011, 04:49:26 PM

Title: Input pin preconfiguration
Post by: DonH on May 21, 2011, 04:49:26 PM
I am trying to use input #1 for a z axis slowdow limit, but it is preconfigured as guards open. I cannot find where to change this. I have looked in config-ports & pins & general config. Can anyone help?

Thanks,  Don
Title: Re: Input pin preconfiguration
Post by: Hood on May 21, 2011, 04:53:41 PM
Its General Config, lower left.
Hood
Title: Re: Input pin preconfiguration
Post by: DonH on May 21, 2011, 05:34:18 PM
Thanks Hood. It must be my age.