Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: olf20 on May 21, 2011, 07:37:54 AM
-
Just purchased this and trying to find what inserts this
uses.
Excello R8 Mill Cutter 1.9" 48mm base XLBN-200
Any information would be appreciated.
olf20 / Bob
-
Take a pic of the seats and post it and likely someone would be able to take a guess, also the measurements of the seat would be good.
Hood
-
Attached are some pictures of the face mill. I'm needing to know what type
of inserts to purchase for this.
olf20 / Bob
-
Without any measurment references, I believe those are TPG322
Dave
-
Thanks for the reply Dave!!
What measurements could I get to confirm?
Thanks again!!
olf20 / Bob