Machsupport Forum
Mach Discussion => FAQs => Topic started by: landonlewis on May 14, 2011, 07:10:16 PM
-
I have a new shopdroid, with a G540 controller and Mach3 w/Lazycam. I have X and Y running well and will run G-code, but I haven't integrated my plasma cutter yet. I am now trying to setup my touch and go for my z axis. This is very confusing. I have installed the Mach XML file and altered it to my config, but this is all so new to me I am having a hard time. My z home touch switch is wired to the input and i can see it activated from my diagnostic page, but does not touch and back off as I would like. Any HELP Would be GREAT!
-
I'm looking for help with this as well.
-
In all fairness this is the MACH3 forum not the SHOPDROID forum. I would start over at the Shopdroid forum as THEY would have the working knowledge of the Shoipdroid setups.
Just a thought, (;-) TP