Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Chip on November 28, 2006, 01:18:42 PM
-
Hi,Art, Brian and All
Is there a way Mach3 can follow a X,Y path, set to pick-up Z value (set to probe at X Y move distance say .250) and incorporate it into a new file with X Y Z moves.
Need to trim off some excess edges, on some (one off) curved shapes 2 x 4 feet, plasma, Water-jet ?.
Any Thoughts Ideas ??
Thanks, Chip
-
Not at this time... What you are looking at can only be done with the teach wizard at this time.
Thanks
Brian