Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: LAMEIII on May 08, 2011, 08:44:15 PM
-
I'm a newbie who just started using Mach3 and I have what may be a silly question. When I'm exiting Mach3 I get a message asking if I want to "Fixture Save".
I haven't been able to locate anything on this and was hopping someone might help me with this.
Thanking you in advance for any assistance you can provide.
Lameiii
-
It is asking IF you want to save your current fixture location.
You can turn this off in Gen Config.
(;-) TP