Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Merv on May 01, 2011, 12:34:29 PM

Title: Incrimental mode
Post by: Merv on May 01, 2011, 12:34:29 PM

Sorry to bother you guys but I just cant remember how I managed to set the incremental mode on mach3.
I run an older version and it crashed. I lost control of the motors and things just would not work properly, so I set up a new preference and it is fine except for the incremental mode! I have a newer version in the house and that is just a question of altering the general config menu. But on this version there is no general configuration menu and I just cant remember how I changed it before.
Merv

Title: Re: Incrimental mode
Post by: Merv on May 01, 2011, 03:40:07 PM

O.K
Remembered. Under the state menu!
Merv