Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: oakmeadows on April 30, 2011, 11:50:48 AM

Title: Limit switch question
Post by: oakmeadows on April 30, 2011, 11:50:48 AM

I have been setting up my limit swiches on my cnc router .I have wired my switchws in series and gone into the BOB pin 13 and earth now whilst testing by jogging the machine in one direction the switch stopped my table dead which i thought was wonderfull but when i try to reset mach3 it wont let me because my switch is still open so could anyone please tell me how to get around this little problem.
thankyou

Title: Re: Limit switch question
Post by: stirling on April 30, 2011, 01:38:09 PM

Hi - tick auto limitoverride on the settings screen.

Title: Re: Limit switch question
Post by: oakmeadows on April 30, 2011, 01:56:34 PM

Alright i will give that a try thankyou