Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: MR MOTION on April 29, 2011, 09:46:55 AM
-
Thank you to all who have replied to my call for help for the "X" axis.
After setting the debounce to 1000 my "Z" axis homes appropriately. The possibility that my "home" switches are causing the problem with the "X" axis is very high;; the switches are magnetic switches.
I feel that after re-adjusting the height of the switch to the magnet, I should not have a problem.
Thank you again.
-
Mr Motion, please reply in your posts instead of making a new thread each time as it makes following things much easier :)
Hood