Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: RandomCheese on April 28, 2011, 11:32:01 AM
-
Is there a way to combine the "Cut Arc" wizard and the "Write Wizard" so that you can engrave text on an arc? If not, is there another wizard out there that accomplishes this same function?
-
Try this http://www.ncplot.com/stickfont/stickfont.htm
Tweakie.
-
That works very well. Thank you.
-
I use deskengrave it is free and works well.
Just a thought, (;-) TP