Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: MR MOTION on April 27, 2011, 05:42:23 AM

Title: homes properly
Post by: MR MOTION on April 27, 2011, 05:42:23 AM

Running mach3 and PCB-gcode
heat ref all home


Y axes will always stop when it hits the home switch and
backs up and homes properly

X axes will always stop when it hits the home switch .
IT STOPES NO backing up and homing properly

Title: Re: homes properly
Post by: andrewm on April 28, 2011, 03:01:15 PM

Try reading this thread:

http://www.machsupport.com/forum/index.php/topic,18276.0.html