Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: anthony.zulli on April 24, 2011, 02:02:27 AM
-
Hi, I am sure someone can help as I have no where else to look !!!!
I have a sun1888 chip on a 4018T parallel port. The I/O is OxDF00 and OxDD00 but its not working when I use this on Mach3.
What can I do to get me CNC working??
-
howdy, did you find the address in device manager or just took it from the manual?
Mine had 3 different address ranges.(found in device manager) the first address did not work but the second went just fine.
Have fun, and tell us if it works now.
-
Hi asw - it was in device manager - I have now replaced it with a different brand and its fine now :-)
AZ
-
Glad to hear that everything is OK now.