Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: mickelsen on April 22, 2011, 12:33:48 AM
-
I've seen mention of an axis calibration function. I've looked through all of the pull-down menus but I can't find it. Could someone tell me where it is located?
Thanks,
Mark
-
This function is not in the menu option.
Look at page SETTINGS (Alt-6)
Bottom left , you will see Axis Calibration, just above the Reset Button.
Jeff
-
I also thank you I was just going to ask the same question. But thought I would check first. and I found this one.
It has been a long time for me sence I last did a set up on my machine . Couldnt find the set up option.
Thanks again from larry in canada as well.