Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Samuelisaac on April 17, 2011, 03:10:11 PM
-
Does anyone know or it is possible to get a PWM signal of 0-10v out of mach3, until now i get max. of 3,22 v, so my spindle is only getting max 1/3 of the speed!!? ???I use a thirdt party breakout of Granite and a second parralelport. Is my PC able to create 10v at all?
-
Not directly, but there are spindle drive boards out there that connect either via the PP or modbus. Peter Homann sells both varieties I think. Some break out boards have that built in.