Machsupport Forum

Support => Forum suggestions and report forum problems. => Topic started by: dchutchins on April 15, 2011, 07:32:30 PM

Title: posting not showing up
Post by: dchutchins on April 15, 2011, 07:32:30 PM

I posted a CNC lathe for sale in the bargin basement section & the post didn't show up & now when I go to try to load it again I get the message that the file name of my pictures already exists so my stuff is there somewhere. I can't find the post elsewhere. The posting was for a spectralight/Shirlins CNC lathe for sale.

Thanks,
dchutchins

Title: Re: posting not showing up
Post by: jeep534 on February 06, 2013, 09:08:24 AM

I am having the same problem

archie =) =) =)

Title: Re: posting not showing up
Post by: Overloaded on February 06, 2013, 09:11:52 AM

Hey Arch ...
  Try again but rename the attachments first.
It must be a name that has NEVER been used before, make the names unique.
Russ, from eastern WV hills.

Title: Re: posting not showing up
Post by: jeep534 on February 06, 2013, 09:16:00 AM

ok I will give it a shot. we must get together sometime.
archie =) =) =)

Title: Re: posting not showing up
Post by: Overloaded on February 06, 2013, 09:20:34 AM

Sure, next time I fly down to Ferguson, I might just give you a call.
Go by you on occasion to Greenbo and Grayson Lake, KY.
Would like to see your shop.
Russ

Title: Re: posting not showing up
Post by: jeep534 on February 06, 2013, 09:23:40 AM

Russ,
     my shop is 1 mile off of the interstate exit 1

Title: Re: posting not showing up
Post by: Chaoticone on February 06, 2013, 11:18:48 AM

The pictures may be too big.  If they are still not there, try posting smaller pics.

Brett