Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Riley on April 13, 2011, 10:40:44 PM
-
OK....So how do I go about thread milling NPT? I did find a macro but it didn't run correctly, but I am new to this, could have been me. Have used the thread milling wizard with great results but have the need to run NPT threads quite often.
-
dont think the wizards can handle tapered threads so your best option would be CAM.
Hood
-
The wizard will work if you have a NPT thread mill.
-
Thats a good point.....I will check into that.
-
IF you look on the manf sites for thread mills most have a wizard that can produce the threadmill code for both single point and multi point setups.
Also I think there is a programable macro in the mach tool box section for TMilling npt threads inside and outside.
Also I believe SheetCam has a threadmill modual as well, not sure if it does npt
(;-) TP