Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: studysession on April 09, 2011, 12:10:46 PM
-
When going from single start to 5 start screws - My steps were always 2000 before, how do I know what to change it to now?
I am very happy how smooth the X & Y axis run with the new screws. I will change out the screw for the Z axis another day. Right now just want to know how to calculate my steps with the 5 start screws.
Thanks!!!!
-
Need to know the TPI then divide by 5 and use that to work it out.
Hood
-
It's an ACME 12-10 5 start right hand screw
Thanks
-
I preume that will be 10 TPI so it will take 2 turns to move one inch.
Hood
-
Got it -
Thanks Hood - you always save my day!!!!
-
No probs :)
Hood
-
The Hoodinator strikes again ;D