Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: cdis on April 06, 2011, 10:21:24 PM
-
My feed rate is set at 1.00. I try to change it to 75.00 but it will reset to 1.00. I have tried to change it both on the "program run" and the "MDI" Hope you can help. SOrry for being such a novice. Neil :P
-
Is it possible the velocity is set to one in the motor tuning.
Is it the same for all axes.
Jeff
-
There's probably an F1 in your g-code.
-
I will check that
Thank you