Machsupport Forum
Third party software and hardware support forums. => SmoothStepper USB => Topic started by: thosj on April 04, 2011, 07:32:26 PM
-
So, Pins 1A, 1B, 1I on the SS? Are these Port 3 Pins 1-3 respectively? And although I don't need them now, what ports/pins are the differential inputs?
I'm at the moment wanting to run my spindle index signal into the SS, but for the life of me I can't remember the port/pin deal even though I'm sure I knew this at one time!! Reread the doc and searched a bit, but can't seem to find it.
Thanks,
Tom
-
They're listed on page 20 of the SS manual-
1A - 1
1B - 2
1I - 3
2A - 4
2B - 5
2I - 6
-
Ah, man, I Hate it when I do that. I read thru the doc and got to all the Windows install bits and thought I was done and didn't find it. I should have printed it, or found my printed copy and I'd have seen that.
Sorry!
Tom
-
No problem.
I'm sure we're all guilty of not being able to see the wood for the trees at times!