Machsupport Forum

Third party software and hardware support forums. => PoKeys => Topic started by: oxxyfx on April 01, 2011, 07:49:30 PM

Title: Plugin missing from the list
Post by: oxxyfx on April 01, 2011, 07:49:30 PM

Hello,

I just recevied mu pokeys55T today. I isntalled it on the CNC computer, the software, upgraded the firmware and I installed the plugin to MACH 3 as well. However when I am going to enable it in the Plugin control - the plugin is not there. What am I missing?

Thanks,
Oxxy.

Title: Re: Plugin missing from the list
Post by: oxxyfx on April 01, 2011, 08:10:15 PM

My bad. Found it, the installation directory for Mach3 was not in the default Mach3 - so the pokeys plugin was not installed where it was expected.