Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: sign solutions on March 21, 2011, 01:51:19 PM
-
MACH3 STOPS AT ERROR " zero radius arcLine 502
machine just hovers over this point
is this a config setting that needs to be altered ?
HELP
-
More likely it is the code that is bad.
Hood
-
Post the line of code that are bad
Hard to tell with just the error code
This is a reply to the same problem at the zone:
Found the problem to be in the drawing, well I say that, I resolved the problem by redrawing one of the arcs.
The problem occurred where one arc joined another. Looking at the CAD drawing everything looked fine, the 2 arcs met exactly, however when the drawing was loaded into LazyCam and the offsets done there was a gap between the 2 arcs??
Found by loading the .tap file into NCPlot.
Interestingly the problem was not there before the offsets were done??
Jeff