Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: adscnc on March 08, 2011, 02:43:20 PM

Title: Auto zero not working
Post by: adscnc on March 08, 2011, 02:43:20 PM

New build plasma machine.
I can get the x and y to ref fine but it does not zero.
Have read 1 other post on this but not much help.
Al
UK

Title: Re: Auto zero not working
Post by: Hood on March 08, 2011, 04:19:02 PM

Config menu then Homing and limits, chose the Auto Zero option for each axis you have.
Hood

Title: Re: Auto zero not working
Post by: adscnc on March 08, 2011, 04:41:23 PM

I've done that,  my x and y auto zero homes are ticked but it doesnt work.

Title: Re: Auto zero not working
Post by: Hood on March 08, 2011, 04:44:06 PM

Are you looking at the machine coords as it is them that zero when homing. If you are looking at an offset you have set up (normal view of DROs) then you will not see them zero as they will show the offset.
Hood