Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: 1000ipm on February 20, 2011, 11:37:00 PM

Title: Y AXIS STICKS when you assign hotkey
Post by: 1000ipm on February 20, 2011, 11:37:00 PM

Hello,

 I have finished a new screen set for my 4 axis hotwire cutter.  When I use the mouse to depress the Y++ or Y-- buttons - DROs jog properly and stop when I release mouse button.  My XBox360 controller moves the y axis properly with the default plugin settings.  If I assign a hotkey to the Y axis and depress the key - DRO moves in the correct direction - but does not stop when I let go of key.  If assign hotkeys to the other 3 axis in the same fashion - I get the correct result - push button axis moves - let go of button axis stops.  What am I missing?  Running Licensed Version R3.042.040.

Thanks,

Kris

Title: Re: Y AXIS STICKS when you assign hotkey
Post by: Hood on February 21, 2011, 03:25:55 AM

Is this

Quote

assign a hotkey to the Y axis and depress the key -

in the plugin and using the X Box or?
Hood

Title: Re: Y AXIS STICKS when you assign hotkey
Post by: 1000ipm on February 21, 2011, 09:02:57 AM

I assign the hotkey in the screen designer with either a standard Mach button or an image button  - essentially just calling the action from the keyboard.


***  Not to muddy the waters - but when I assign X and A ++ / --  to an image button I get the same result.  If I assign
the X and A ++/-- to a stock Mach button it works fine.