Machsupport Forum

Third party software and hardware support forums. => dspMC/IP Motion Controller => Topic started by: adamsj3 on February 16, 2011, 02:13:14 PM

Title: can't update
Post by: adamsj3 on February 16, 2011, 02:13:14 PM

I just downloaded the latest software and firmware updates.  The installer bombs because I'm not connected to the internet to download some microsoft program.  What's the work-around?  I've done a search on the forum but didn't find anything.  I think it's ridiculous to assume every mill is connected to the internet.

JA

Title: Re: can't update
Post by: Vital System Support on February 16, 2011, 03:06:22 PM

microsoft setup programs may require to download .net framework.  sorry dont know any work-around.  you may want to check microsoft websites for any solution.

reagrds,
Rufi