Machsupport Forum

Third party software and hardware support forums. => Mach3 and G-Rex => Topic started by: autostaff on February 14, 2011, 08:08:14 PM

Title: Arrow key worked now they don't
Post by: autostaff on February 14, 2011, 08:08:14 PM
Hello all,

I'm very new to the CNC world so for give my ignorance. I set Mach 3 up as the tutorials show. I loaded my first "G" Code and turned the Plasma on and made a part. After doing this the Arrow keys no longer work to jog the X and Y axis I can use the MPD buttons to move the axis but not the arrow keys. Any Ideas what the heck I screwed up. One other issue I am having is that Mach3 seems to forget the soft limits and over run. Could some of this be my motor drivers.

Any help would be appreciated.

Thanks