Machsupport Forum

General CNC Chat => Show"N"Tell ( Your Machines) => Topic started by: ialbazae on November 18, 2006, 12:46:24 PM

Title: This is the machine i built
Post by: ialbazae on November 18, 2006, 12:46:24 PM

Hi all

i just built a big router table its working area 1500 mm for x and y axis 200 mm for z axis

i used two parallel large slide pars for x axis with two stepper motors and one for y axis and a small one for z axis

i want to thank art soft for mach3 it is a very nice software.

i did the open sign with vcrave demo it is the 1st work i do with my machine i got a good result  ;D

but i faced a small problem with changing the tool bit i lost the zero hight so what is the best way to change the bit and maitain the zero hight? ???

see the pics

thank you
ialbazae

Title: Re: This is the machine i built
Post by: ialbazae on November 18, 2006, 12:54:19 PM

hi again

i foreget to ask you about the router!!!!!!!!
i am using a noisy router what is the best router for cnc?

Title: Re: This is the machine i built
Post by: DennisCNC on November 18, 2006, 09:28:46 PM

^^ Thats a hard one.  If you want quiet it will cost $$$$+

Title: Re: This is the machine i built
Post by: ialbazae on November 19, 2006, 03:39:19 AM

How much it will cost and where can i find one??????????

Title: Re: This is the machine i built
Post by: DennisCNC on November 19, 2006, 01:32:21 PM

Well, eBay is the cheaper way to go if you find one.  If you want a new one it will be $2,000 min for a spindle, brands like HSD, Colombo search on google for high speed spindle.

Title: Re: This is the machine i built
Post by: Tony Mac on December 06, 2006, 03:12:48 PM

Hello ialbazae,

Great to see your machine and the results are excellent!

I sent you an e-mail message but it was bounced back?

Tony