Machsupport Forum
Tangent Corner => Tangent Corner => Topic started by: fer_mayrl on November 17, 2006, 02:40:48 PM
-
DOes anyone know of any software that has the ability to program slower feedrates when the cutter is fully engaged?
I hate to program feed of 10ipm in aluminum because the cutter cant handle 50ipm cuts when it is fully engaged, but when only 20, 25, 50% of the cutter engaged it can cut at 50ipm, but since the programmed feed rate is 10ipm it takes tooo long to cut.
Regards
Fernando