Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: widpyro on February 05, 2011, 07:05:55 PM
-
Does anyone have g-code for cutting NEMA 23 and NEMA34 motor mounts? This would cut a recessed circle and the four mounting holes.
thanks,
-jim
-
If you can provide me with a dimensioned drawing of what you want and the tooling your using I can put it into g-code for ya.
-
This sounds like it could be an ideal job for the wizards already built into Mach.
It does not have to be all done as one file as long as the origin is the same you could use two or three programs with tool change in between as necessary.
Tweakie.