Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: dresda on February 02, 2011, 12:29:56 AM
-
Is it possible to use my 3 Dc servo motors with 10 v analogue and DSPMC unit and a stepper motor with it's own drive for the rotary table.
Ray.
-
Hi Ray,
In short yes.
Mach outputs step and direction signals (in an open ended manner) and it really does not care what type of drives/motors you are using.
Tweakie.
-
I dont think the DSPMC can use Step/Dir drives so I would say no. Rufi will be able to give you a definitive answer though.
Hood
-
Ooops,
Hood is quite right, I was only considering mixing servo drivers and stepper drivers and not operation of Mach under the DSPMC plugin. :-[
Tweakie.