Machsupport Forum
General CNC Chat => Show"N"Tell ( Your Machines) => Topic started by: LEZALLEN on January 28, 2011, 11:42:44 AM
-
I have just acquired this cnc lathe with a transformer box (grey box) there are 5 wires from the emcotronic t1 panel but i have no idea where they are supposed to go into the transformer or what power supply into the transformer any ideas
-
You will have to post a picture of wire and transformer in order to get help.
Jeff
-
Hi Jeff here are a few photos
-
Lez,
As it says on the label that is a 3 phase auto-transformer.
Couple more questions for you,
Do you have a 3 Phase supply available to use with your machine ?
What is the voltage marked on the machine motor ?
What is the voltage of your incoming mains supply ?
Tweakie.
-
Tweakie
I do have 3 phase supply available
The voltage on the machine motor is 380
and the incoming mains voltage is 440
thanks LEZ
-
Hi Lez,
The incoming 3 Phase supply connects to the three 440V terminals.
The machine connects to the three 380V terminals BLACK - RED - BLACK (the GRN/YEL connects to earth on the box and your site earth - the BLU is already connected to the Neutral terminal [240 Volt tapping]).
Test earth bonding of the machine and box etc. before proceeding.
When you start the machine motor, if it runs backwards, just swap the connection of any two wires on the incoming 440V side.
Take care, 440Volt 3 phase is serious stuff - don't let it get you. ;)
Tweakie.
-
many thanks tweakie for all your help
-
I have now wired the machine up but the monochrome screen keeps rolling and i keep getting an alarm 02 main drive not ready any ideas how to rectify this problem
LEZ