Machsupport Forum

Third party software and hardware support forums. => Sieg Machines => Topic started by: rasc on January 27, 2011, 03:40:56 PM

Title: Tapping on KX3
Post by: rasc on January 27, 2011, 03:40:56 PM
Hi Everyone
Is it possible to tap on KX3? I see that G84 rigid tapping is disabled for this m/c. In a previous life I used similar code to this to cross tap with a power tool on a mill turn m/c
G0 Z3 M3
G1 Z-10 F27
G1 Z3 F33 M4
if I can find out if this works I will try to source a floating tap holder
Many thanks
Ray