Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: adryan on November 13, 2006, 03:20:16 PM
-
Hi,
Perhaps it's only with my installation but after updating from 2.003 to 2.009 the feed++ /-- and inner knob of the shuttle pro stoped working.
Do I need to alter some settings for rel. 2.009?
Following I downgraded to rel. 2.003 and everything worked fine again....
-
Ya know, I had a problem with mine too. EVERYTHING stopped working. I re-downloaded the plugin and re-installed the plugin and everything OK. It's one of the WTF's????