Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: bret4 on January 02, 2011, 10:32:56 AM
-
I have a Dell Inspiron 8200 laptop computer. I went through the optimizing and it passes the driver test. Only question now is will it run a Gecko G540? It does not have a EPP parallel port. It only has Normal, ECP or Bidirectional. Is it absolutely necessary to have a EPP parallel port to run the G540 with Mach3?
-
I think Bi-Directional setting would work, but its been a long time since I have used the Parallel Port with Mach ::)
Hood